| This head tracker adopts a geomagnetic sensor, compare with a conventional gyro, it is more accurate and has no drift. Specifications:
Weight: 10g
Dimension: 40 x 28 x 7mm
Power supply: powered from transmitter trainer port (such as Futaba 9 to 12-channel transmitters square trainer port)
Packing method: bare PCB, no outer case/packing
Sensor type: Geomagnetic sensor, 3-axis Programming: Menu Content Menu 1: Blink once, Set X-axis channel Menu 2: Blink twice, Set y-axis channel Menu 3: Blink 3 times, Set z-axis channel Menu 4: Blink 4 times, Set X-axis ratio Menu 5: Blink 5 times, Set y-axis ratio Menu 6: Blink 6 times, Set z-axis ratio Menu 7: Blink 7 times, load default Enter the menu
Holding the button, then turn on your radio , head tracker’s blue LED will quick flash once ,this means You have entered the setup mode Then the LED will flash out menu form 1 to 7.when you see the menu you want, release the button . and the LED will quick flash once again . this means You have entered this menu . Menu 1-3 Set x,y,z-axis channel, when you push the button once, current channel will move to the next channel, until 9 channel it will back to 1channel. In this setting mode current channel will automatic move up and down and the other channel will keep midpoint .at the same time LED will flash out current setting. The settings will immediately saved, cycle power to use it. Menu 4-6 Set x,y,z-axis ratio, when you push the button once, current ratio will go highier ,until stage 9 it will back to stage 1. In this setting mode only current axis is activated .you can move the head tracker find the best ratio . at the same time LED will flash out current setting. The settings will immediately saved, cycle power to use it.
|
